Bonjour,
depuis un peu plus de deux jours je n’ai plus d’interface eth0 sur ma squeeze…
Je n’ai pas souvenir d’avoir fait des mises à jour avant mais seulement d’avoir démarré sur deux live-cd : ubuntu 11-10 et tangostudio. Les lives CD n’ont pas eu accès au réseau et c’est là que ça a commencé.
dmesg | grep eth0 donnait ceci :
[ 0.828349] r8169 0000:02:00.0: eth0: RTL8168d/8111d at 0xffffc9000067a000, 20:cf:30:50:c7:64, XID 083000c0 IRQ 35
[ 14.224130] r8169 0000:02:00.0: eth0: unable to load firmware patch rtl_nic/rtl8168d-2.fw (-2)
[ 14.231100] r8169 0000:02:00.0: eth0: link down
[ 14.231419] ADDRCONF(NETDEV_UP): eth0: link is not ready
J’ai téléchargé le paquet firmware-realtek depuis une autre machine et je l’ai installé à la main, maintenant si je refais dmesg | grep eth0 j’ai ça :
[ 0.807643] r8169 0000:02:00.0: eth0: RTL8168d/8111d at 0xffffc9000067a000, 20:cf:30:50:c7:64, XID 083000c0 IRQ 35
[ 14.171070] r8169 0000:02:00.0: eth0: link down
[ 14.171386] ADDRCONF(NETDEV_UP): eth0: link is not ready
# arp
Address HWtype HWaddress Flags Mask Iface
192.168.1.254 ether 00:1b:bf:1c:39:de CM eth0
[code]# ifconfig
eth0 Link encap:Ethernet HWaddr 20:cf:30:50:c7:64
inet adr:192.168.1.103 Bcast:192.168.1.255 Masque:255.255.255.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:220 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:1000
RX bytes:13200 (12.8 KiB) TX bytes:0 (0.0 B)
Interruption:36 Adresse de base:0xa000
lo Link encap:Boucle locale
inet adr:127.0.0.1 Masque:255.0.0.0
adr inet6: ::1/128 Scope:Hôte
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:11210 errors:0 dropped:0 overruns:0 frame:0
TX packets:11210 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:0
RX bytes:1371147 (1.3 MiB) TX bytes:1371147 (1.3 MiB)
[/code]
# route
Table de routage IP du noyau
Destination Passerelle Genmask Indic Metric Ref Use Iface
192.168.1.0 * 255.255.255.0 U 0 0 0 eth0
default 192.168.1.254 0.0.0.0 UG 0 0 0 eth0
# lspci
00:00.0 Host bridge: Intel Corporation Core Processor DMI (rev 11)
00:03.0 PCI bridge: Intel Corporation Core Processor PCI Express Root Port 1 (rev 11)
00:08.0 System peripheral: Intel Corporation Core Processor System Management Registers (rev 11)
00:08.1 System peripheral: Intel Corporation Core Processor Semaphore and Scratchpad Registers (rev 11)
00:08.2 System peripheral: Intel Corporation Core Processor System Control and Status Registers (rev 11)
00:08.3 System peripheral: Intel Corporation Core Processor Miscellaneous Registers (rev 11)
00:10.0 System peripheral: Intel Corporation Core Processor QPI Link (rev 11)
00:10.1 System peripheral: Intel Corporation Core Processor QPI Routing and Protocol Registers (rev 11)
00:1a.0 USB Controller: Intel Corporation 5 Series/3400 Series Chipset USB2 Enhanced Host Controller (rev 06)
00:1b.0 Audio device: Intel Corporation 5 Series/3400 Series Chipset High Definition Audio (rev 06)
00:1c.0 PCI bridge: Intel Corporation 5 Series/3400 Series Chipset PCI Express Root Port 1 (rev 06)
00:1c.4 PCI bridge: Intel Corporation 5 Series/3400 Series Chipset PCI Express Root Port 5 (rev 06)
00:1c.5 PCI bridge: Intel Corporation 5 Series/3400 Series Chipset PCI Express Root Port 6 (rev 06)
00:1c.6 PCI bridge: Intel Corporation 5 Series/3400 Series Chipset PCI Express Root Port 7 (rev 06)
00:1c.7 PCI bridge: Intel Corporation 5 Series/3400 Series Chipset PCI Express Root Port 8 (rev 06)
00:1d.0 USB Controller: Intel Corporation 5 Series/3400 Series Chipset USB2 Enhanced Host Controller (rev 06)
00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev a6)
00:1f.0 ISA bridge: Intel Corporation 5 Series Chipset LPC Interface Controller (rev 06)
00:1f.2 SATA controller: Intel Corporation 5 Series/3400 Series Chipset 6 port SATA AHCI Controller (rev 06)
00:1f.3 SMBus: Intel Corporation 5 Series/3400 Series Chipset SMBus Controller (rev 06)
01:00.0 VGA compatible controller: nVidia Corporation GT218 [GeForce 210] (rev a2)
01:00.1 Audio device: nVidia Corporation High Definition Audio Controller (rev a1)
02:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 03)
03:00.0 SATA controller: JMicron Technology Corp. JMB362/JMB363 Serial ATA Controller (rev 03)
03:00.1 IDE interface: JMicron Technology Corp. JMB362/JMB363 Serial ATA Controller (rev 03)
04:00.0 FireWire (IEEE 1394): VIA Technologies, Inc. VT6315 Series Firewire Controller (rev 01)
07:01.0 RAID bus controller: Silicon Image, Inc. PCI0680 Ultra ATA-133 Host Controller (rev 02)
Le contenu de mon /etc/network/interface :
[code]# This file describes the network interfaces available on your system
and how to activate them. For more information, see interfaces(5).
The loopback network interface
auto lo
iface lo inet loopback
The primary network interface
##allow-hotplug eth0
#NetworkManager#iface eth0 inet dhcp
Connection éthernet automatique si réseau existant :
auto eth0
iface eth0 inet static
address 192.168.1.103
netmask 255.255.255.0
gateway 192.168.1.254[/code]
voilà je suis complètement coincé là…