Bonjour,
J’aurais besoin de votre aide concernant un souci de règles de routage sur mon PC.
Mon PC (sous Debian Jessie) est configuré comme tel :
- eth0 avec IP fixée à 192.168.3.2 (déclarée dans /etc/network/interfaces)
- wlan0 en bail DHCP statique (fixé à la MAC) sur 192.168.4.2
J’ai branché mon NAS sur l’interface eth0 de mon PC et wlan0 me sert pour me connecter à Internet (via ma Freebox).
Le problème est que lorsque je démarre, j’ai accès à mon NAS mais je n’ai pas accès à internet.
Je suis donc obligé de couper eth0 pour accéder à Internet (mais je perds évidemment l’accès à mon NAS).
Autrement dit, je n’arrive pas à faire en sorte d’accéder à mes deux réseaux simultanément.
Voici le détail :
Au démarrage, pas d’accès à Internet :
root@whitelight:/home/openpanic# ping 8.8.8.8
PING 8.8.8.8 (8.8.8.8) 56(84) bytes of data.
From 192.168.3.2 icmp_seq=1 Destination Host Unreachable
From 192.168.3.2 icmp_seq=2 Destination Host Unreachable
From 192.168.3.2 icmp_seq=3 Destination Host Unreachable
^C
--- 8.8.8.8 ping statistics ---
4 packets transmitted, 0 received, +3 errors, 100% packet loss, time 3015ms
pipe 3
Voici l’état de ma table de routage :
root@whitelight:/home/openpanic# route -n
Table de routage IP du noyau
Destination Passerelle Genmask Indic Metric Ref Use Iface
0.0.0.0 192.168.3.1 0.0.0.0 UG 0 0 0 eth0
0.0.0.0 192.168.4.254 0.0.0.0 UG 1024 0 0 wlan0
192.168.3.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
192.168.4.0 0.0.0.0 255.255.255.0 U 0 0 0 wlan0
Et mes interfaces :
root@whitelight:/home/openpanic# ip a
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: eth0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast state DOWN group default qlen 1000
link/ether 14:da:e9:43:2f:14 brd ff:ff:ff:ff:ff:ff
inet 192.168.3.2/24 brd 192.168.3.255 scope global eth0
valid_lft forever preferred_lft forever
3: eth1: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast state DOWN group default qlen 1000
link/ether 14:da:e9:43:27:ad brd ff:ff:ff:ff:ff:ff
4: wlan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
link/ether 00:18:f8:a4:6e:10 brd ff:ff:ff:ff:ff:ff
inet 192.168.4.2/24 brd 192.168.4.255 scope global dynamic wlan0
valid_lft 43009sec preferred_lft 43009sec
inet6 fe80::218:f8ff:fea4:6e10/64 scope link
valid_lft forever preferred_lft forever
Et si je coupe eth0, je récupère internet :
root@whitelight:/home/openpanic# ifdown eth0
root@whitelight:/home/openpanic# ping 8.8.8.8
PING 8.8.8.8 (8.8.8.8) 56(84) bytes of data.
64 bytes from 8.8.8.8: icmp_seq=2 ttl=56 time=30.9 ms
64 bytes from 8.8.8.8: icmp_seq=3 ttl=56 time=29.4 ms
^C
--- 8.8.8.8 ping statistics ---
3 packets transmitted, 2 received, 33% packet loss, time 2000ms
rtt min/avg/max/mdev = 29.451/30.210/30.969/0.759 ms
Le contenu de mon fichier /etc/network/interfaces :
[code]root@whitelight:/home/grobs# cat /etc/network/interfaces
This file describes the network interfaces available on your system
and how to activate them. For more information, see interfaces(5).
The loopback network interface
auto lo
iface lo inet loopback
auto eth0
iface eth0 inet static
gateway 192.168.3.1
network 192.168.3.0
netmask 255.255.255.0
address 192.168.3.2[/code]
Merci d’avance 
OpenPanic